Products

This 7 way connector is designed to mate to Bosch Motorsport Ignitors, and comes with the connector, 18ga terminals and straight boot.

NOTE: This is not the correct telemetry system required for GTD teams competing in the IMSA WeatherTech series.   Bosch LTE65 Telemetry System Bosch LTE65 Telemetry system provides unparalleled speed and reliability for data communication between the car and the pits. Utilizing Verizon cellular coverage,...

Replacement antenna for GT cars that mounts on the inside of the windscreen

12V Power supply unit for the Bosch LTE65 Pit Harness terminated with a DTM06-2S connector.

Replacement wiring harness for pit side communications with Bosch LTE65 telemetry systems. Note: The Pit Harness does not include Power Supply. These can be ordered separately here: Bosch LTE65 Pit Harness Power Supply.

Bosch M5 ABS Clubsport Kit – Precision Motorsport ControlWhat’s more terrifying than going from Vmax into the braking zone at turns 10A and 10B at Road Atlanta (or even the Safety Pin (T7) at Sebring) and losing control of your car due to wheel...

Bosch MSA Box II Diagnostic Cable  Commonly referred to as the Bosch MSA cable, MSA 2 cable, or even trackside as “that damn ABS cable,” is the essential diagnostic and calibration tool for professional motorsport teams. Designed by Bosch Motorsport as a cost-effective yet powerful...

The PSS is specially designed to measure absolute pressure in gasoline direct injection applications. This sensor is also compatible with other kind of fluids e.g. Diesel, engine oil, transmission oil or brake fluid. The sensor uses a thin layer technique to achieve high accuracy...

The Bosch Motorsport Steering Angle Sensor (LWS) is a professional-grade, high-speed CAN bus steering position sensor designed for motorsport applications where precise vehicle dynamics data is critical. Whether you're integrating a Bosch Motorsport ABS M5 Kit, MoTeC ECU, Bosch Motorsport ECU, or professional data...

Description Documentation Specifications Outputs • LED Indicating Power on Beacon signal received Error codes • Digital output for beacon information (alternative to CAN output) Communications • CAN bus used for: Communicating beacon information Communicating diagnostic information Configuring the receiver via the BR2 configuration software...

Designed and built by AvioRace, and packaged together as a kit! The IP64 rated miniaturized infrared temperature sensors are specifically designed for contact free brake disc temperature measurement for motorsport. With a fully sealed, red anodized aluminum body, the sensor contains three highly accurate elements...

Description Documentation • Compact, lightweight housing in a low-profile design with high-density packaging • Robust 4 mm standard jacks for measuring leads • Signal integrity of high-speed data links ensured by product-specific version • No more lost jumpers due to patented 90° rotatable connectors...

Description Documentation Specifications Outputs • Coded infra-red beam Range up to 40 meters (130 ft) when used with BR2 • 3 color LED status indicator for: Power OK Low battery Fault or very low battery Power • External via a 12 V rechargeble battery...

Description This 12v Color Bullet CCD Camera allows for a signal input into a color display for viewing live on screen imagery. Can be used as a reverse camera, and displayed under user derived conditions or via a driver operated switch. The C125, C127...

Basic Specifications Display • Screen: Color TFT LCD, anti-reflective • Selectable fixed layouts with channel and label configurability • 48 user-defined, scrollable message lines with programmable overrides • 3 programmable 'pages', for example Practice, Warm-Up, Race Communications • 2 x Configurable CAN buses with...

The C1212 Track Kit includes: • C1212 Display • 10 Hz GPS • Two buttons, pre-wired • Professional quality plug-in loom, terminated and labelled, with plug-in power adapter • Ethernet Cable C1212 Track Kit Options • The C1212 will connect directly to the factory...

The C125 Accessory Kit includes: • 10 Hz GPS • Two buttons, pre-wired • Professional quality plug-in loom, terminated and labelled, with plug-in power adaptor • Ethernet cable The C125/C127 Accessory Kit is a cost-effective, plug-in display solution based on our new full color...

Display • Screen: Colour TFT LCD, anti-reflective• Resolution: 800 x 480, anti-aliased graphics• Selectable fixed layouts with channel and label configurability• 48 user-defined, scrollable message lines with programmable overrides• 3 programmable 'pages', for example Practice, Warm-Up, Race Communications • 2 x Configurable CAN buses...

Basic Specifications Display • Screen: Colour TFT LCD, anti-reflective • Resolution: 800 x 480, anti-aliased graphics • Selectable fixed layouts with channel and label configurability • 48 user-defined, scrollable message lines with programmable overrides • 3 programmable 'pages', for example Practice, Warm-Up, Race Communications...

The C125 Track Kit includes: • C125 Display • 10 Hz GPS • Two buttons, pre-wired • Professional quality plug-in loom, terminated and labelled, with plug-in power adapter • Ethernet Cable C125 Track Kit Options • The C125 will connect directly to the factory...

Now with up to 32 GB of logging via USB! The C125 is a popular model in MoTeC's range of color Displays and Display Loggers. Striking in design and powerful in functionality, the C125 offers display, data logging, auxiliary control and programmable LEDs all...

The C127 Track Kit includes: • C127 Display • 10 Hz GPS • Two buttons, pre-wired • Professional quality plug-in loom, terminated and labelled, with plug-in power adapter • Ethernet Cable C127 Track Kit Options • The C127 will connect directly to the factory...

MoTeC is very excited to announce the release of our new Display Creator software. Display Creator is a unique graphics application for customizing screen designs on MoTeC’s color displays and loggers, namely the D series and C series. This incredibly flexible software allows customers...