All Products

IMSA Safety Light Antenna Kit for the following cars that have the Black MSE ICars Safety Light Track Condition Radio This antenna kit is to be used in conjunction with an MSE Box for all cars competing in Weathertech series and LMP3's in VPX.

IMSA 1 Bar Pressure Sensor for Airbox, manifold pressure in NA cars and restrictor pressure.  

This Ethernet communication cable can be used to download all Bosch dash, logger and MS6 or later ECU’s. This is not for communicating with any ABS systems. For ABS systems a MSA-2 Cable is required which can be purchased here.  A rugged mil spec...

Adapter used to adapt the manufacturer supplied logger adapter to the IMSA XAP logger system in Porsche 718 Cayman GT4 cars. Note: This part is required for 2025 competition.

The XAP LED Position Panel (also known as the Leader Light Panel) for IMSA Competition. Kit includes the LED Driver box, 2x LED panels and optional 2x 3 meter extensions to connect the panels to the module.Can Communication - 1 x 2.0b not terminated Can...

Replacement IMSA Yellow LED Warning Light used in all IMSA safety light kits.

IMSA 3.5 bar Boost pressure sensor for forced induction cars in the Weather Tech Championship.

Description Technical Data LDL TPMS Sensors can be configured to use with Beru F1 TPMS Systems. They can be ordered as direct replacement for the following F1 Beru Sensors: F1-100-1521-011 (25 mbar per bit version 1 Hz update rate)F1-100-1521-010  (14.7 mbar/bit version 1 Hz update...

Description Specifications Performance • 10 Hz update rate • 66 satellite channels • Dynamics 4 G • Power supply voltage 4.0 - 6.0 V Communications • RS232 • 38400 Baud rate Compatible with • MoTeC C125, C185 • MoTeC ACL • MoTeC ADL3, ADL2 (not compatible with original...

Mating connector kit for Bosch Motorsport MS6 series ECU 91pin. Includes housing and terminals

Mating connector kit for Bosch Motorsport MS6 series ECU 105pin. Includes housing and terminals.

The PSS is specially designed to measure absolute pressure in gasoline direct injection applications. This sensor is also compatible with other kind of fluids e.g. Diesel, engine oil, transmission oil or brake fluid. The sensor uses a thin layer technique to achieve high accuracy...

Bosch Compact 6-Way Female Connector Kit, currently only available in the Code 1 configuration. Most commonly sold as individual pieces, we've included all the required parts in one kit to make life easy for the installation of a Bosch Throttle Body.Code 1 kit includes:1x -...

Mounting Plate for the Bosch MM510 IMU.  This damping plate has  special vibration absorbing/temperature stable urethane pads that reduce unwanted high frequency vibrations from affecting the devices measurements. It has 2 X M8 mounting bungs for mounting the plate to the car, as well...

The IMSA Team Alert Safety Light System (TASL for short) can be used (but are not required) in conjunction with the IMSA Safety Light System across all IMSA series. Easy mounted on the timing stand/pit box with the supplied mounting bracket, the three lights provide a 360 degree...

Green LED to be mounted on the rear bumper area of all Weather Tech Championship cars. The light is terminated with a DTM04-2P connector with the following pin out. 1. Ground2. Power +12vTeams will need supply power via a DTM06-2S connector with the same...

Connector Kit for Bosch Direct Drive Wiper Motor Note: Lin and Analog drives use the same connector

The rugged 2 GB USB flash drive is securely mounted within a rugged brass housing designed to provide full protection against extreme environmental conditions. It is IP68 protected and resistant to extreme operating temperatures (-30 to 85°C). The USB flash drive is equipped with...

The high resolution bullet camera is a sealed IP67 rated unit, with an auto-iris, auto-white balance and Sony chipset allowing them to perform under varying sun & light conditions with true day and night modes. Additionally, we then add a high definition 120 degree lens to the camera...

1/2 Wave Dipole Antenna for Tire Watch TPMS Systems,