Expanders

Description Specifications Inputs • Knock sensor input • Knock window input • Power supply (8V) Outputs • Knock signal • Audio Compatible with • ‘Hundred series’ ECU – M400, M600, M800 and M880 using ECU Manager software v3.5 and up • i2 data analysis...

The Stack ST8956 Multi-Function Recorder (MFR) can monitor a range of values, known as performance parameters, needed for effective car and driver management in most competitive situations. The system consists of a 14 input sensor module with a built-in 32 MB data recorder. All...

Description Specifications Inputs • 4 x Digital/speed inputs Communications • MoTeC specific coded signal supplied to an ECU digital/speed input Compatible with • All MoTeC ECUs Physical • Case size 70 x 100 x 35 mm excluding connector • Weight 215 grams The Traction...

Description Specifications Inputs • 4 x Digital/speed inputs Communications • MoTeC specific coded signal supplied to an ECU digital/speed input Compatible with • All MoTeC ECUs Physical • Case size 70 x 100 x 35 mm excluding connector • Weight 215 gram • 1...

Description Specifications Inputs • 6 x Fast analog voltage inputs Update rate 5000 Hz (1000 Hz when used with ADL3) , resolution 12 bit Used to measure the signals from sensors with variable voltage outputs, such as potentiometers, 3-wire pressure sensors, thermocouple amplifiers, accelerometers...

Description Specifications Outputs • 8 x Ignition outputs Suits most ignition modules of falling edge type The dwell time is controlled by the ECU For 10 and 12 coil applications, two IEX units can be used Communications • MoTeC specific coded signal supplied from...

Description Specifications Inputs • Update rate for all inputs 200 Hz, for a second expander 50 Hz • 2 x switch inputs • 4 x digital inputs with frequency measurement and switched capability • 2 x cold junction compensation thermistor inputs • 8 x analog...

Description Specifications Inputs • Update rate for all inputs 200 Hz, for a second expander 50 Hz • 2 x switch inputs • 4 x digital inputs with frequency measurement and switched capability • 2 x general purpose temperature inputs, calibrated as Bosch water...

Description Specifications Inputs • 8 x analogue voltage inputs, used for the motor position sensors Outputs • 4 pairs of servo motor drive outputs (full bridge) Communications • 1 x CAN, for configuration and connection to the ECU Compatible with • M400, M600, M800...