Accessories

Description This gauge mount fits all 52 mm Stack gauges. Please Contact Us for further information.

Description Documentation The STC (Serial to CAN) adaptor converts RS232 data to CAN and vice versa allowing multiple RS232 devices to be connected to a Data Logger via CAN. Please Contact Us for further information. Documents Title Type 🗎 Datasheet PDF

Description Connecting to the PC's Serial Port Use either a PC Interface cable (PCI cable) or a Computer Interface Module (CIM). The PCI cable contains electronics in the ECU end of the cable to convert the ECU signals to signals compatible with the serial...

Description Documentation Specifications Outputs • Coded infra-red beam Range up to 40 meters (130 ft) when used with BR2 • 3 color LED status indicator for: Power OK Low battery Fault or very low battery Power • External via a 12 V rechargeble battery...

Description Documentation Specifications Outputs • LED Indicating Power on Beacon signal received Error codes • Digital output for beacon information (alternative to CAN output) Communications • CAN bus used for: Communicating beacon information Communicating diagnostic information Configuring the receiver via the BR2 configuration software...

Description Documentation Specifications Electrical • Output current Continuous DC current 20 A (total) Peak surge current 500 A • Max. operating frequency 50 kHz @ 28 V • Switching delay, typical High to low 6.5 µsec Low to high 6.5 µsec • Input threshold,...

Description Documentation This version is intended for magnetic wheel speed sensors. The signal should be symmetrical around zero volts. Heavy filtering minimizes the possibility of interference, resulting in significant variation of the trigger level with frequency. The Dual Magnetic Converter (DMC) converts magnetic style...

Description Documentation This version is intended for ignition system input conditioners, typically used in drag racing, for measuring ignition timing. The Dual Magnetic Converter (DMC) converts magnetic style signals to open collector output signals – a square wave. This makes a typical magnetic sensor...

Description Documentation This version is intended for engine trigger sensors that have insufficient amplitude to trigger a logic level input. Minimal filtering avoids delays in the signal. The trigger level does not vary significantly at normal operating frequencies. The Dual Magnetic Converter (DMC) converts...

Description Documentation This version is intended for fuel flow sensors which have a very low trigger level. Heavy filtering minimizes the possibility of interference, resulting in significant variation of the trigger level with frequency. The Dual Magnetic Converter (DMC) converts magnetic style signals to...

Description Documentation Applicable MoTeC products • M4 with serial number less than 3000 • M48 • M8 The CIM module is normally installed in the vehicle. This places the electronics in the vehicle rather than in the cable which has the advantage of providing...