Accessories

The Deutsch DT06-2S-E008 Plug comes with the connector, wedgelock and sockets. The DT series are an industry standard size 16 contact connectors, which are rated for 13 amps continuous and will accommodate wire sizes from 14-20 AWG and has a silicon rubber seal. Deutsch DT06-2S-E008 Receptacle Includes:1x - Male Connector1x - Wedgelock...

This 7 way connector is designed to mate to Bosch Motorsport Ignitors, and comes with the connector, 18ga terminals and straight boot.

Deutsch Autosport AS 10 Shell Pin Connectors offer: Two contact arrangements35 - 13 #22 Pins98 - 6 #20 PinsAnd all keyway options are available. Please select the appropriate pin style connector. Choose: Connector Type Contact Arrangement Keyway (Please note, only the same color keyways will...

2 Button Switch harness that is supplied as standard with all Motec "track kit" systems. The buttons are set up to use the Green button for "Page" and the Red button for "Alarm Reset" but this is all adaptable in the dash manager software.

Connector and pins to make your own wiring harness for various models of Motec M1 ECU Connector "B" Backshells are used to provide a better surface to grip shrink boots when creating your own wiring looms.  Raychem 202K153 (straight) or 222K153 (90 degree) boots are what...

Connector and pins to make your own wiring harness for Motec M1 Series ECU's Connector "A"Backshells are used to provide a better surface to grip shrink boots when creating your own wiring looms.  Raychem 202K163 (straight) or 222K163 (90 degree) boots are what fit the...

Description Looking for a way to flush mount your new 15 button keypad? Here is your solution! Comes complete with countersunk bolts and nylock nuts. Just mount your keypad to this piece and mount that into your application! Simple as that! **Keypad not included**...

Description Looking for a way to flush mount your new 8 button keypad? Here is your solution! Comes complete with countersunk bolts and nylock nuts. Just mount your keypad to this piece and mount that into your application! Simple as that! **Keypad not included**...

The 2 meter long Ethernet Panel Mount Cable is used for the motorsport team who needs a custom solution when building their own wiring harnesses. These ethernet communications cords can be used to communicate with a multitude of manufacturers including Bosch, MoTeC and more.

Description Documentation The STC (Serial to CAN) adaptor converts RS232 data to CAN and vice versa allowing multiple RS232 devices to be connected to a Data Logger via CAN. Please Contact Us for further information. Documents Title Type 🗎 Datasheet PDF

Description Connecting to the PC's Serial Port Use either a PC Interface cable (PCI cable) or a Computer Interface Module (CIM). The PCI cable contains electronics in the ECU end of the cable to convert the ECU signals to signals compatible with the serial...

Description Documentation Specifications Outputs • Coded infra-red beam Range up to 40 meters (130 ft) when used with BR2 • 3 color LED status indicator for: Power OK Low battery Fault or very low battery Power • External via a 12 V rechargeble battery...

Description Documentation Specifications Outputs • LED Indicating Power on Beacon signal received Error codes • Digital output for beacon information (alternative to CAN output) Communications • CAN bus used for: Communicating beacon information Communicating diagnostic information Configuring the receiver via the BR2 configuration software...